Skip to Content
(WG154) 20V POWER SHARE 10" CORDLESS STRING TRIMMER & EDGER
Excessive vibrations/noise
Try this solution
Rewind the spool lines or switch it out for a new spool
Possible cause:
Line spool is not wound well.
Click on the guide to learn how to wind the line.
1
Take approximately 10ft (3m) of line
Insert 5/8 inch (15mm) of line into the Spool holes.
2
Wind line in the direction of the arrows on the top of the Spool
Leave approximately 4 inches (100mm) of line unwound and place into the cleat.
3
Ensure that the line is neatly coiled on the Spool
Failure to do so will impair the efficiency of the automatic line feed.
4
Fit the Spool
On this page