Product
(WR150) LANDROID L 20V 4.0AH ROBOTIC LAWN MOWER (1/2 ACRE)
(WR150) LANDROID L 20V 4.0AH ROBOTIC LAWN MOWER (1/2 ACRE)
Common issues
Can't configure Find My Landroid on the App
Can't get into my Landroid App account
Changed wifi
Fritz!box
Grass is being cut unevenly
Landroid cannot correctly dock with the charging base
Landroid does not mow an area within a boundary wire zone
Landroid fails to connect to the internet
Landroid flips over
Landroid is not operating at the correct time
Landroid is shaking heavily
Landroid is starting to have shorter run-times between charges
Landroid operative system crashes when charging or on standby
Landroid reverses or rotates erratically near the boundary wire
Landroid runs outside the boundary wire
Landroid shuts off when docking in the charging base
Landroid slips out of its working area going down a hill
Landroid stops in the working area
Landroid turns on, but the blade disc does not spin
Landroid vibrates
Landroid wheels skid or repeatedly slip
Landroid will not cut on assigned schedule
MESSAGE: Battery temperature out of range! Please wait
MESSAGE: Battery voltage too low! Please change battery
MESSAGE: Blade motor fault! Press START to reset.
MESSAGE: Can’t find charge station press START to reset
MESSAGE: Mower lifted! Press START to reset
MESSAGE: Mower locked!
MESSAGE: Mower trapped! Press START to reset
MESSAGE: Outside working area! Press START to reset.
MESSAGE: Upside down! Press START to reset
MESSAGE: WRONG PIN! Please retry.
MESSAGE: Wheels motor fault! Press START to reset
MESSAGE: Wire missing! Press START to reset
None of the above
Outside
Possible cause: Wire has been cut
Red light on the charging base
Summer
The LED light on the charging base does not turn on
The charging time is far more than the rated charging time
The green light on the charging base turns on before charging is complete
The mower does not charge
Wire has been cut
Your Landroid is inside its working area and the boundary wire is connected, but the display says ‘Outside working area! Press START to reset’
I have a different question