Skip to Content
(WX844L) WORX NITRO 20V 18GA NARROW CROWN STAPLERMy tool will not start
(WX844L) WORX NITRO 20V 18GA NARROW CROWN STAPLER

(WX844L) WORX NITRO 20V 18GA NARROW CROWN STAPLER

My tool will not start

Try this solution

Ensure the battery is fully charged and properly installed.

  1. Make sure the battery is fully seated in the charger. If no light shows, check if the outlet is working. If the charger still shows no light, it may need to be replaced.

  2. Once the battery is fully charged, insert it into the tool.

  3. Select your stapling mode and make sure that the selector is properly seated. This is important to prevent unexpected staple discharge and possible injury.

  4. Push the Workpiece Contact against the work surface first, then squeeze the On/Off Trigger to start.

Remember, safety should always be your priority.

Need more help?

Ask a different question(WX844L) WORX NITRO 20V 18GA NARROW CROWN STAPLER
Select a different product
On this page