Skip to Content
(WG186) NITRO 40V POWER SHARE CORDLESS ATTACHMENT-CAPABLE DRIVESHARE 15" STRING TRIMMERDifficulty winding the line
(WG186) NITRO 40V POWER SHARE CORDLESS ATTACHMENT-CAPABLE DRIVESHARE 15" STRING TRIMMER
Difficulty winding the line
Try this solution
The spool must be wound while inside the trimmer head
The spool cannot be wound with line, then installed into the trimmer head.
Note: If you need replacement spool line, we recommend visiting your local hardware store to purchase the line. WORX does not carry replacement line for this model.
Line size: 0.095 in.
1
Remove the TRIMMER HEAD
To remove the TRIMMER HEAD, press the sides to release it.
2
Prepare the trimmer line
Use line size: 0.095 in. and max length of 10'.
You may use any local hardware store lines.
3
Remove the spool inside of the TRIMMER HEAD (12)
Insert the line through the eyelet of the spool and feed it through the other side. Ensure both ends of the line are even (approximately 5 ft. each side).
4
Feed both ends of the line through the RELEASE TABS (13)
Put the spool back into the TRIMMER HEAD (12). It may take a few seconds to adjust the spool back in. Once it is secure in the TRIMMER HEAD (12), ensure that the line is even on both sides.
5
Attach the TRIMMER HEAD (12) back onto the trimmer
You will hear it click back in place.
6
Turn the TRIMMER HEAD (12) clockwise to wind the line around the spool until about 7.5” remains on either side.
On this page