Skip to Content
(WG124) 6 AMP ELECTRIC 15" STRING TRIMMER & EDGER
Excessive vibrations/noise
Try this solution
Try rewinding the spool lines or switching it out for a new spool
Possible cause:
Line spool is not wound well.
Click the guide for how to rewind the line.
1
Take approximately 16ft (5m) of line and insert 5/8” (15mm) of line into one of the holes in the upper section of the SPOOL
2
Wind the line in the direction of the arrows on the top of the SPOOL
Repeat process with separate piece of line on lower section of SPOOL.
3
Leave approximately 4” (100mm) of line unwound and place it into the cleat
Repeat on the lower section of the SPOOL.
Note: Carefully ensure that the line is neatly coiled on the SPOOL. Failure to do so will impair the efficiency of the automatic line feed.
4
Thread the line through the eyelet of the spool housing.
After you've done this, proceed to install the cap cover.
On this page